Reduced Unsprung and Rotational Mass. Improved Thermal Capabilities. Optimized Heat Dissipation. Designed to Work with OE Calipers
StopTech AeroRotor - Black Hat - Single will improve your vehicle's overall heat capacity, allowing it to outperform stock performance. Because of this, you can apply more force to the brakes stop after stop while still having a lower probability of fading. All of this is accomplished without modifying your car's factory front-to-rear brake torque ratio. They will act to keep the pads from glazing while also adding additional bite, clearing away any debris that develops between the pad and the disc, as well as increasing the braking effectiveness in both wet and dry conditions!
StopTech AeroRotor Replacement Kits ARK are designed to replace your vehicle's original factory rotors, while retaining the factory brake calipers. Although the ARK is the same diameter and thickness as the factory rotors, it offers improved cooling, braking, and handling. The directional, floating AeroRotors allow independent expansion of the rotor and hat without "coning," thanks to elongated drive pin holes. ARK components include AeroRotor friction rings with patented internal vane design, pre-assembled to billet aluminum AeroHats with directional stand-offs that optimize cooling airflow. The patented AeroRotor vane design pushes up to 80 percent more air than factory rotors for better cooling and reduced fade on the track. The aircraft-grade aluminum hats and 2-piece AeroRotors are up to 8 pounds lighter than stock rotors, allowing faster acceleration and deceleration, and improved handling. StopTech AeroRotors are available slotted or cross-drilled. These slots or holes allow better dissipation of heat, friction material and debris, assuring that fresh pad material is in contact with the rotor every time the brakes are applied. An optional anti-corrosion, zinc finish is available for customers in cold climates, where salt and chemicals are used to melt snow and ice. The zinc coating also benefits customers who prefer no visible surface rust on the vanes and outer circumference of the rotors. StopTech AeroRotors are 100 percent made in the USA.
StopTech AeroRotor - Black Hat - Single is engineered to replace your vehicle's OE factory rotors while keeping the factory brake calipers in place. In addition to superior cooling, braking, and vehicle handling, the aero-rotors are available in the same diameter and thickness as your factory rotors This means the rotors have long drive pinholes. This means that the rotor and the top of the hat can be extended without "coning." AeroRotor friction rings with patent-protected internal vane design push up to 80% more air for enhanced cooling and minimal fade.
Airflow is optimized by pre-installing friction rings on billet aluminum AeroHats with directional stand-offs. Both parts are up to 8 lbs lighter than stock rotors and will not slow down your vehicle! The rotors are slotted or cross-drilled for better heat, friction material, and debris dissipation for clean contact between the pad and the rotor. The rotors can be electroplated with anti-corrosion zinc to protect them from salt and chemicals used in colder climates.